50 hp Power Cube Calculations

From Open Source Ecology
Jump to: navigation, search

Prof. Fling;

I've given some thought to the prior calculations - they arrive at a displacement of ~1.17 CIPR, but if I make a Power Cube with this size pump, it won't produce suitable flow. So, I've decided to use a "rule of thumb" to size the pump, basing it on prior experience with engines and the OSE LifeTrac tractor. It goes like this: In the past, the preferred power for the LifeTrac has employed ~54 horsepower @ 3600 RPM to drive two pumps, each about 0.92 cu in displacement. This has proven satisfactory and is the rule against which the new Power Cube will be measured. The total pump displacement was 1.84 CIPR (Cubic Inches Per Revolution). This gives a ratio of HP:Flow of 54:(1.84 * 3600).

For this new Power Cube, the engine will be producing between 50 and 60 hp @ 2700 RPM (the RPM yielding max torque). So, using the above ratio to derive the new displacement as follows for 50 and 60 HP: 54:(1.84 * 3600) = 50:(R * 2700) -or- R = 50 * 1.84 * 3600 / (54 * 2700) = 2.271 CIPR

54:(1.84 * 3600) = 60:(R * 2700) -or- R = 60 * 1.84 * 3600 / (54 * 2700) = 2.726 CIPR So, this "rule of thumb" measurement puts the displacement at about 2.5 CIPR and 28.3 GPM flow: 2.5 * 0.97 * 2700 / 231 = 28.34 I know this doesn't match industry numbers, but I think it is a realistic estimate for this application.

Do you have any thoughts about this?

Regards,

Tom Griffing


Tom & Marcin, etc: Has anyone ever put a pressure gauge on the powercube when being used on the lifetrack, etc to see what the relief valves are set at? This might be some of the discrepancy of the calculations if you or the calculations are assuming 3000psi and its not achieving that. Also, please see my suggestion on the car page about having the pump on one side of the engine crankshaft and a direct drive option on the other. I feel confident this is more mandatory then a suggestion, but hope you will engage the discussion if you disagree. -OpenSourceCitizen