Cold Saw/V1 Design Files/Support Bar
< Cold Saw | V1 Design Files
Support Bar
- Length: 300mm
- Width: 127mm
- Thickness: 25.4mm
- Shaft Hole Diameter: 32mm
- Shaft Hole Spacing Along Length: 260mm
- Shaft Hole Spacing Along Width: 23.5mm
- Shaft Hole Spacing: minimum of 40mm from part ends
- Interface Hole Diameter: 12mm
- Interface Hole Rectangle: 75mm x 80mm
- Stopper Hole Diameter: 12mm
- Stopper Hole Spacing: 30mm x 45mm from Shaft Hole. (Such that the blade bottoms out just before touching the vise; such that the drive assembly can reliably and safely sit back without being held)
- Stopper Notes: Remember that the stopper screw will have a nut on it which determines the contact diameter of the stopper.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF