File:D3DOriginal config.ini

From Open Source Ecology
Jump to: navigation, search
D3DOriginal_config.ini(file size: 10 KB, MIME type: text/plain)
Warning: This file type may contain malicious code. By executing it, your system may be compromised.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current02:56, 20 June 2017 (10 KB)Marcin (talk | contribs)Working version for production printing. Z offset is ~0, it doesn't appear to work. Z offset is set in hardware by single probing to determine 100 microns above print surface. PLA setting, 1.75mm, 205C nozzle and 60C bed.
18:40, 10 June 2017 (10 KB)Marcin (talk | contribs)OSE Lulzbot Cura settings with OSE Marlin: Max Z feed rate increased from 5 to 10 mm/s via M203 in Start GCode Travel speed reduced from 150 to 80 mm/s in Advanced Settings Infill speed reduced from 80 to 50 mms/s in Advanced Settings
04:40, 10 June 2017 (10 KB)Marcin (talk | contribs)Turns extruder heater and bed heater off.
04:33, 10 June 2017 (10 KB)Marcin (talk | contribs)Overrides Extruder Steps per mm setting of OSE Marlin with M92 E100 - or 100 extruder steps per mm of filament. This was measured using 1.75 mm PLA filament in D3D Original 16".
22:18, 9 June 2017 (10 KB)Marcin (talk | contribs)Added: set bed to standby temperature, and set extruder to 100C.
21:17, 9 June 2017 (9 KB)Marcin (talk | contribs)Set filament to 1.75mm and temperature to 205 for PLA. Bed is 60.
21:07, 9 June 2017 (9 KB)Marcin (talk | contribs)
  • You cannot overwrite this file.

The following 3 pages link to this file: