Hydraulic Motors

From Open Source Ecology
Jump to: navigation, search

Low Cost

  • $150, 1500 in lb [1], 14 hp. Npte that the heaviest [2] are only about 16 hp for 3x the cost (of course with higher torque).
  • Largest ($880) is 40 hp, or about 2x more expensive per hp than the small motors) [3]

PTO Motors

High Speed

  • 1 cu in, 3000 RPM cont, 2500 PSI, 15 GPM requirement, 5/8" shaft - $220 - [4]
  • 1.5 cu in, 7/8 13T spline - 20 gpm for 3000 RPM - $130 - [5]. Needs coupler - [6]

High Torque

  • BMER-2-250 - 6000 in lb [7]. 1.25" taper. With castille nut, easier mounting. But CCW rotation, not reversible?
    • 30 hp
  • Check.pngBMER-2-250- taper or straight - $330 - [8]
  • Note you can get BMER-2-350 for just a little more, at 33% extra torque.
  • Bailey, 6000 in lb , $350 [9]
  • 14 cu in 6000 in lb, $330 [10]
  • 13k in lb - $1300 - Charu-Lynn [11]
  • 9000 in lb $549 [12]. BMER1-540

3000 In Lb Range

  • 15 cu in gerotor - 3300 in lb - $135 new but stay away from poor seller - [13]
  • Note - these are much cheaper than the 5000 in lb + range.
  • $109 - 3000 in lb [14] no case drain.
  • BMPH 200 series - $169 - 3100 in lb - [15] but has case drain.
  • Note that the 9.59 cu in PTO motor is in the range - [16]
  • BMP400 - 23 cu in - 4200 in lb - $180 - [17]

BMER-2 Specs

Part Numbers